Re: 2 bar map sensor

[steve ravet <sravet@arm.com>]

John_Calabrese@ENGELHARD.COM wrote:
> 
> The new LS1 motors MAP sensors are 0-5 volt.  I kow this because when I was at
> school I was team leader for the ethanol vehicle challenge, which converted an
> LS1 to run on E85.  I also built about 5 of these motors, and designed and built
> and installation kit for a vortech s-trim supercharger (have picsif you want to
> see them).  I also know every table and map inside the 1999 truck ECU.  What we

Is the truck motor LS1, or is that only the aluminum block?

Anyway, if you aren't prohibited from posting the information, I'm sure
there would be plenty of interest in seeing the code and/or maps from
that ECM.


-- 
Steve Ravet
steve.ravet@arm.com
Advanced Risc Machines, Inc.
www.arm.com
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org