Re: added baro sensor to 730

["John S. Gwynne" <jsg@jsgpc.mrcday.com>]

| Kewl, thanks
| Just a note thou what do you mean by GF14?.  The pinout table I have Shows
| A-F, no GF, or is this some other way of id'ing where the sensor attachs?.

The service manual I have adds "B" for the black connectors a-d 
and "G" for the green (which looks more like yellow to me:). 
So... yes, sensor gound (pin a) to b6, sensor power (pin c) to a4, 
and signal (pin b) to f14.

I've also put the binary image on the ftp site if you want to 
give it a try. Configured for 2-bar MAP sensor, ALDL mode 11, 
and added baro sensor (a regular 1-bar MAP sensor).

john gwynne


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org