Re: How to do 165 to 730

["Bruce Plecan" <nacelp@bright.net>]

> If I wanted to change my 87 Vette to 730, how would I do it, in
> general. 
> Do I need to change a lot of wiring/connectors?  
> No... just need to take all the pins out of the 165 harness, and put
> then in the 730 connector. 
> I just use the wiring diagram  which I still have to find (think is
> on ftp site) find it on 165 diag, and 730 and swap.. I used the wires for
> the maf so that I did not have to add any.
> Do I need to add any
> other sensors besides the MAP?  
> Nope
> Where does the MAP go and how do I put it
> there?  
> I put mine on fire wall.. use the oem hose from map and stick it on
> one of the vacume ports on ps near rear...
> FPR gets the vac signal from same spot.
> Thanks.

will take a *custom* chip for the VSS in you 87.
Grumpy 

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org