Re: Mods to '85 GM TPI ECM

["Bruce Plecan" <nacelp@bright.net>]

That *can* include full time baro.
Grumpy


> There is a code patch around for running a two bar map with a 730 too!
> Mark

> > Jim and Sharon Brady wrote:
> > > But
> > > if/when I go with a supercharger I will definately need the 730/MAP.
I
> say
> > > if because of the cost of a supercharger and when because this motor
was
> > > built for it: 9.25:1 compression(Al heads), forged pistons, 4 bolt
> > > mains...etc.
> > When you go unnaturally aspirated, you'll either need to go with a
> > '6870/'165 and a monster MAF, or a '749 and a two bar MAP using the SyTy
> > code.  If you go to the '730, you'll later be able to switch to the '749
> > with little trouble.  The '730 and '749 are built on the same circuit
> > board, just with different portions populated or empty.
> > Ludis Langens                               ludis (at) cruzers (dot) com


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org